Feel a little stupid asking this but I didn't pay close enough attention when the guy I was buying my Kubota B8200 from installed the pump on the Woods 650 backhoe attachment to the PTO shaft on the tractor. There is a large ring on the shaft that he ether turned or pulled to get it to lock on...
I have a good BK7 trencher that I took off a very wore out B7100 gear drive tractor that had the optional extra gear reduction type shifter on the trans. in order to make it travel slow enough to let the trencher dig. My question is if I build a sub frame to adapt it to my B8200 hydro will it...
I have a mid 80's B8200 in my shop that belongs to an old friend of mine that has the splines on the input shaft of the hydrostat and the coupler striped out. I am going to split the tractor tomorrow to see if there is any other damage. How big a job is it to replace to input shaft of the hyro...
I have a wore out B7100 DT that has a very good B1630 FEL on it and have a chance to buy a L245DT. Can the B1630 FEL be made to work on the 245 or is it just to small to be practical?
Has anyone tried replacing the steering box on these tractors with a small P/S box off say a Mazda P.U.? I realize you would have to make a support for the steering column but that can be done. This would be helpful for loader work. I think the next time I am at Pull A Part I will look over some...
I have removed the trencher from my B7100D and am going to put it on a heaver tractor that I have and put a 3 point system on the 7100. My question is what all arms will fit the 1977 B7100D be for I go looking. I wouldn't think that they would be to expensive used as they shouldn't be a high...
Just got a B7100D in bad /neglected shape. It has a B1630 loader on it and a Kubota trencher on the back. It would be real handy around here if I can get it up into shape. The story I got was that it was jumping out of gear under load but don't know if they meant the trans. or the PTO. Got about...