Recent content by birddog0304

Stopped at red lite and saw this next to me. Light changed and he got on I-40. I'm sure the dead tree will hold down that sheet of OSB.. Right?

Curious how many hours people have and what kind of problems they have seen. I have 3100 hrs. Had both drive motors replaced and a solenoid on valve bank go out as far as major issues.

A series Cranked easily and let warm for 20 mins. Backed out and moved 20-25 forward when forward progress stopped. Unable to move forward or reverse, loader still functional. Raised inside (seat)arm and checked outside, no problems. Returned to seat, put arm down and directional indicator...

We use 2 feed trailers. Load them at the shed and put them at different areas of the pasture. I have noticed a decrease in hay requirements as well as very little waste. Also time required to feed has decreased. Just another option to consider. I know it would not be optimal for everyone.

Here is one on eBay. You can see the supports as well as the warmer doors

32F this morning, gonna be dropping down later this week. Had a heavy fog yesterday morning that froze on the trees and other growth. This picture is the frozen fog on my grape vines, reminded me of the velvet on a deer's antlers.

Found this on eBay $85 moody9904 Parting out a 60 that was running. Phone number was included.

Looking to run a 7 ft sickle mower from an 8-10 gpm hydraulic pump. Sickle mower was belt driven off a midmount pto. What hydraulic motor (size) would be needed? Thanks

Many of the early sixties to the early eighties tractors and maybe later (eg. 3010/3020/2030/2640) had the mid mount pto on them. Is it possible to add one on to a tractor that does not have one(2240), only the bearing housing as in the diagram (#9)? Sorry, can't seem to get the...

Thinking about putting a 6 ft bush hog on front of my A series Toolcat . Any thoughts, opinions or experiences?

Had my toolcat about 3 mths now. Its an A. Used it mainly to feed this past winter. Starting moving some dirt and noticed I couldn't push and then I couldn't raise the loader until I changed directions. Changed both filters and cut the old ones open, they were clean. Still having same...