Recent content by blkqi

@xyz123, what is you way of getting g a saw clean before working on it. I've been using oil eater for the tough stuff, but they never seem to look as immaculate as that one. On another note, what would you say about this Cman saw? Think it's a Poulan 3400(?). Low compression but P&C looks good...

After replacing the impulse line the 3000 started right up. I had to order a new vent line since the one on it did not have an appropriate valve. Comes Saturday. Put on a Tsumura 16" .325 bar and BPX chain and did my best to tune the carb... Motor starts easily and runs strong. With low and...

Here is a picture of my supposed barb:

Looks just like the one in your c30.jpg image. I only have $10 into it so far.