Bob Gibson's latest activity
-
BBob Gibson replied to the thread Offered another unusual project.A third option would be to line the pond. It would probably cost less than a well.
-
BBob Gibson reacted to etpm's post in the thread Another looking for a flux core MIG welder suggestion thread with
Good Post.
There is a welding process called dual shield that uses a flux cored wire along with shielding gas. It is used for putting down lots of... -
BBob Gibson reacted to etpm's post in the thread Another looking for a flux core MIG welder suggestion thread with Good Post.
I understand your reticence to use gas, especially if you can't just exchange a cylinder. Though I am surprised that you can't exchange...
-
BBob Gibson reacted to WinterDeere's post in the thread Another looking for a flux core MIG welder suggestion thread with Good Post.
But they're heirloom bottles! :ROFLMAO: I feel sorry for anyone so caught up in what.. the $250 cost of a friggin empty bottle...
-
BI believe you remove that bolt and then push that rod gland assembly back into the cylinder a ways to expose the retaining ring.
-
BBob Gibson reacted to AaronD81's post in the thread "AGM Car" batteries for less used tractors? with Good Post.
I switched to AGM for my tractor, got it at Costco. You should be fine with a normal battery. I found that a direct replacement was...
-
BBob Gibson replied to the thread My Stupidity kicked in at full throttle..Disassemble the drive shaft by taking the cross out of the yoke, then just use a bearing puller hooked onto the yoke and pull against...
-
BBob Gibson reacted to mllud's post in the thread My Stupidity kicked in at full throttle. with Good Post.
Could you take the u-joint apart and then possibly use a puller.