Recent content by BobLou

It finally got warm enough I was able to take the front end appart, fount a damage bearing, and seal''s Bought the bearings locally for both wheels, $199.00 plus tax, the seal are bob cat specific. $17 each, need 2 But just before I took it appart, my tractor front wheels would lock, and the...

Now that you tell.me the seals are Bob Cat specific, I probably will order the seals before I start the work, I do not want the tractor out of commission for too long. I was hoping to take it appart and find seal here in my town, for a BOb Cat dealer it's a 3 hour drive one way... Thank you.

I'm not even sure what seal is leaking I know it's both side front axles that are leaking I'm afraid to take it appart only to find that the seals are back ordered for the next 6 months. Lol So I wanted to at least get the seals before opening the axle. Now you are saying there are more than...

Today I noticed my front seals are leaking, both side. How do I replace them. I do not have a service manual. Do I need one for this? I know I must remove the wheels but then how much work is it? How much time should it take? Am I talking a day or a week. Do I need a puller? Any advice...

⁶

I have the exact same tractor with 2000 hours, the same thing happened to me this spring. A pump is $6000.00 in canada. And a hole lot of work to replace I to have a front bucket and I know the little 4 inch rubber hose you are talking about. Behind the bucket brakets. I also have a rear...

Hello I had the same issue it took me a long time to figure out it was a relay. When turning the key do you hear the relay "clik", if not I would start there, you say if you jump tge starter it starts. So it might also be a safety switch, One under the seat, 1 for rear PTO, one for mid PTO...

Seville, I agree. I will get 2 new hydraulic filters. Yes this tractor has 2 and I'm not sure what one does Vs the other, so 2 filters, then on the suction side of the pump I will replace the o rings, and Bob Cat inserted a small 4 inch rubber hose in between the suction line and the pump, so I...

Well, after talking to 2 mechanics, i have air in my hydraulic system...could be an O ring, could be a pump, could be a plugged intake... I will need to do more research.

Same thing happened to me, on both side of the tractor I cut the the line took out 5 inch and welded 2 hydraulic nipples males. then I had a 5 inch hydraulic line with 2 female union made to insert in between my cuts, now the rubber hydraulic line takes the vibration. I did this at about 700 hours.

I think its a relay. Do you hear a clicking sound when you turn the key? You should, relay. Same thing happened to me on a CT235 a few years back but i cannot remember what and where that relay was. Try to jump the starter, it should start.

Hello I was using me tractor and it stop going forward, no power in any of the 3 gears low, med high, it still has some reverse I was not sure but this week it seems that it would slow down, not allot but i did not know if I was imagining things... I have check the oil, for some reason it...

I live in northern Ontario its often -40F We plug in the tractor at night with a block heater. Also if the tractor is only at iddle it will never heat up, it will run at corrrect temp only if we increase the rpm Last week My tractor temperature would not come up. The gauge would move but just...

I live in Northern Ontario, its -40F. I need a block Heater on my tractor. I did the same thing about 1 month ago, forgot to put the fuel cap on my tractor while snowblowing, after 1 hour of blowing notice my tractor was not running well. Then i saw my mistake, no cap.. I used about one cup...