Recent content by bobsphotos

Problem solved. John Deere provides an electrical block under the hood for connections. ACC.,B+,and Neg. Bob W

I have a brand new JD open station 3046R tractor and I have installed a Summit Hydraulics rear and front remote kit. I need advice on the best place to tap into 12v power. The kit came with a device called " add a fuse", but my fuse block has a sealed cover and the is no entry from the back of...

Thank you John. I didn't see this response come in.

Changing the draft control lever did not change the behavior. Any other ideas?

Thanks, i will check that.

I haven’t used my 641 for about a year. When i fired it up recently, it started and ran fine but the lift arms do not move until the lift lever is about half way through its stroke. For the last half of the stroke it is fine. Hyd level is fine. Any thoughts on where to start?

I am looking at the Kubota RTV-X900 to use for cleaning a cow barn, horse barn, and a goat barn on a small farm. The large majority of what we clean ends up being pine shavings that we use for bedding. I would like to increase the dump capacity with sideboards because the pine shavings have more...

Good morning, Can I put rear chains on my 749 all steer without rubbing issues? Thanks, Bob W

This is going to seem like a weird question but I have a 2017 X738 with the Kawasaki motor which stinks when I start it up. The exhaust smell is so nasty, I will not start it up in my shop. It is better once it has warmed up but still really smells. It has 40 hours on it and has smelled since...

I recently started doing volunteer work at an animal sanctuary and they have 2 tractors. A JD 2520 Hydro and an oldie but goodie JD 950. People will start these tractors and put them right to work with no warm up. For example, it is -6 F here this morning. How long do you folks let your...

I have bought a New To Me L3400 with FEL and want to add a 2 spool remote valve. I have a pretty good idea where and how I will mount it, but I need help with the plumbing. I would appreciate help from anyone out there there that has installed the OEM remotes or has done an aftermarket install...

Front tire chains on X738 I bought a new X738 with the 47" snowblower at the end of last winter. I works very well but I am looking for more traction. I have rear chains and built a weight box. Has anyone out there put on front chains? Thanks, Bob W

Good morning, I cannot figure out where these bumpers go from looking at the CNH parts page. Could someone snap a picture of one of these bumpers on their tractor? It will be much appreciated. Bob W

It took some time and money, but my lift issue is fixed. Here is what I had to do to get it fixed. I did the following troubleshooting: 1. I checked the pump pressure as outlined in the I & T Shop Manual and I had a solid 2000 PSI 2. I also have a Ford 641 so I installed the lift cover from that...

Parts #40 & #41 are the 2 "O" rings used when the manifold is used. Bob W