Recent content by boomerfun

  1. B

    plowing with a hydro

    I know a hydro isn't in first case the transmission for plowing But is it bad for the hydro to use a 2-14 plow and in what gear What other work can i do with it (groundwork) disks...?? tc 40 da
  2. B

    tc 45 da vs tc 48 da

    What is the best chose In first case for mowing but straight lines and only a few trees. And FEL work ( a bit and not in narrow places ) clutch wear?????? and at least tillage (6 foot and 8 inch deep)
  3. B

    tc 45 vs 40 da

    I am looking for a boomer bus i am doubting between a tc 40 da and a tc 45 da, a friend of me said to buy the tc 40da because it has a lot of power, much cheaper and the with the hydro there is only a little difference between the 2 i will pull a mower for lawn mowing how big can i go wtihout...
  4. B

    landini mistral

    Can someone tell me some + and - points of it
  5. B

    hydro vs manual

    Now i drive a tc 40 da (hydro) but is it possible to buy me a tc 45 with 12x12. Or better again a hydro. It is for lawn + finish mowing (only a few trees and only 4 corners, a bit of plowing and tillage. But a friend of me said: there is a possibility for problems with my clutch after a time...
  6. B

    tc 40 da

    Now i drive a tc 40 da (hydro) but is it possible to buy me a tc 45 with 12x12. Or better again a hydro. It is for lawn + finish mowing (only a few trees and only 4 corners, a bit of plowing and tillage. But a friend of me said: there is a possibility for problems with my clutch after a time.
  7. B

    1920 12x12

    I had a question about the 12x12 manual of a NH 1920. I it +- the same as the 12x12 of a tc 45? Is it possible the use it for mowing (lawn and finish), it is an open field or better the manual of a tc 35/40/45
  8. B

    hp of a tc 40/45

    The hp's of a tc 40/45 is 40/ 45 ph but what type of hp is it ISO or DIN?
  9. B

    jinman

    maybe a strange message but are there pictures of your boomer jinman??
  10. B

    Mowing  flail mower with tc 40/45

    Is it possible to pull a flail mower (72 inch) with a tc 40/45 d hydro? It is for light cutting (most of the time finishing mowing).
  11. B

    tc 40- 45

    I need a new boomer for finish mowing/lawn mowing/hay/a bit of transport/ making and a bit of gardening. But what is the best chose a tc 40/45 and a hydro or a manual transmission Is it difficult to work with manual for mowing (not mush trees in my way and only 4 corners).
Top