Recent content by BowlBuilder

I've always liked and wanted a Case 210, but ten horsepower seems a little on the low side. Would a 14 h.p. engine from a 224 (or 444) be a direct bolt in for the 210? I thought they might have used the same engine from the 220 for the 210 as a cost saving measure. If so, how would the...

A friend recently acquired an older Case 444. It does not have the snap fast system, but he plans on buying a later style frame and modifying his tractor for the snap fast setup. I assume it is between the years 1969 - 1971. The tractor has the factory optional hydraulic lift on the right side...

Tom, you and Casey are probably two of the most informed people I know when it comes to this brand of tractors. I am certainly glad Casey is here as I told him where you could be found (not that he couldn't have figured it out). My question is have you contacted anyone and asked them to come to...

I've seen the three point plans on a lot of sites. I believe they originated on the Yahoo group. My question is: Has anyone seen a drawing or set of plans for the HH-34 hitch? BTW, here is a three point hitch which sold on ebay lately which seems to be well thought out and executed...

New Improved Front Axle Pin Ingersoll Lawn Tractor Mower 226 444 448 3016 4020 | eBay I've seen a few of these lately and wondered if anyone knew the exact length of the pin as I would like to make one myself. Seems to kill two birds with one stone. Thank you.

ATTENTION STOLEN TRACTOR RECOVERED

I have a K36 splitter (love it) but don't like putting hours on my onan engine. How would this splitter perform if I were to build a separate portable hydraulic system with a standard 2 stage 11 g.p.m. splitter pump and a 5.5 horse Honda engine? Thank you in advance for any opinions on this...