I am looking at a W4 that has a pto, but I am not sure about a three point hitch. Want to purchase it to pull a brush hog. Can a brush hog be used without a standard three point?
I have read that the W4 is a real work horse.
Thanks
I am looking at purchasing a new Billy Goat brush cutter. About $2900. I want the three speed with the Honda engine. I see other brands out there, but having recently rented a Billy Goat I believe it will work for me.
Anyone have their opinion on this brush cutter?
Thanks,
Bridge Boy
On my 1950 8n I am having a difficult time re installing my brake retracting spring to the two spring anchors. I hope I have the correct anchors as they do seem to be somewhat sloppy where they fit into the brake shoe. They were on tractor functioning ok before. They move as I am attempting to...
Talked to a guy today that has a Farmall H that he may sell. Tires and engine are good. He did point out to me that if I understood him correctly, that at times the transmission will not allow you to take it out of gear to return to neutral. He said he has had to remove the top cover to allow...
I just picked up my radiator for my 8N that I had rebuilt. Installed it on my tractor and noticed that the radiator cap wing does not point straight back or you might say not centered like it was before. Now it is on an angle that looks to be 8 o clock in direction. I assume they may have...
I have a lead on a D 4 which is a 1940's vintage. Owner claims that pony and engine is decent, but that right steering clutch is in stuck position. Wants $3900. I have read that this repair is not to bad on a older D4. Your thoughts.
Thanks,
BridgeBoy
I have located an Oliver 550 for sale for $3500. From what I see there doesn't seem to be a lot of them locally. People say they are a good utility tractor, but I have a concern for replacement parts. Anyone out there with this model tractor?
Thanks,
BridgeBoy
I recently purchased a 1952 8N just as a collector tractor. The previous owner used the blue silicone gasket material in a tube form rather than the $2. gasket that should be used for the govenor housing and it does have oil leaking. Will replace with the proper gasket shortly, other than...
Looking at a Farm Pro 2420. 2003 year. 2 wheel drive. Can purchase for $2200. 400 hours. Would like to use with a 4 foot brush hog. Is this a good tractor?
Thanks,
BridgeBoy
I am seeking information or advice on a Massey Harris 20 or 22 that the owner claims that a new exhaust manifold gasket is needed to make engine operational. Said that exhaust manifold gasket is bad and is pushing coolant out exhaust pipe. Trying to decide asap if I should even consider buying...
I have been talking with a gentlemen that has either a Massey Harris 20 or 21. He is not sure of model. WFE. Claims that intake gasket is leaking so coolant is only going into exhaust. Not into oil pan. Shut down and decided to sell as is.
Are parts available for this year and model...
I am looking at a 1949 8N that the owner claims the only way it will start is by pull starting. He said it smokes and will start with starter after pull starting for the day. I kind of guess rings are bad. It looks to be in over all good shape as far as tires and paint. Comes with 6 ft...
Hi,
I am looking at a D 14 that does not have a front end loader. Any idea on cost, used for a front end loader.
Is it practical to go this route since tractor is $2700?
Thanks,
BridgeBoy