Recent content by BrkMstr

Placement of load, obviously weight needs to be on trailer tires, hard to get one trailer to fit all vehicle lengths - sometimes placement requires backing on trailer - equipment / buckets up front seem to balance a little easier, if you are new get a weight scale hitch, or simply use a scale...

You show a CK25, if that's correct you do not have regen, idle will not affect yours as it would regen units, I only idle to warm it up when needed for a couple of minutes. Outside of that I shut it down, the regen should not be idled, if I do leave it running it's running at minimum of 1800 rpm

Don't know him, don't know where he lives, doesn't seem you've have much contact with him on the Forum, but first thought, first inclination was "have tractor will help" - very nice to see there are a few like you still around - don't know you, but thanks........

Yes it was that line, by the looks the factory had tightened the ends and painted, never noticed or checked that one of the Banjo's was not set right, O ring must not have been set right, split when tightened / off center - I believe the paint held it for awhile until pressure finally blew it...

When I listed my tractor on Craigslist Aug 2021, I received four of those, "can't make it but will take it" offers, did not answer any of them, they are scams, they have been around for a long time and I'm sure they will continue to try and steal all they can. If you had answered and gone along...

Tractor has found a new home and is doing well!! FYI: Typing to fast - hands quicker than mind I guess - should have posted it as Hydraulic Top Link - not center link - had both top and bottom - The Hydraulic Tilt was for the chute on the snow blower - it had a lot in the package and I was...

Life provides challenges and we are downsizing to a single level home with a small lawn and I no longer need my tractor, I am hopeful it will find a "good home" as it's been an excellent unit - I've attached a "small list" of the items - as like most of you I've outfitted it well.... Contact...

I think you addressed your own disappointment - I have 22K Generac - it was installed by the seller / electrical contractors - decent size business, they have their own factory trained service techs, I have a maintenance agreement with them, the unit was bought with a 10 yr warranty - they show...

I do not believe the 4WD indicator light is set up for that tractor - each model offers different standard features, however the indicator lights are included with them all and come on at start up - mine does not activate the 4WD light when in gear but will at start up - my prior 2610 did not...

This morning when I got up I had three grays and four reds under the bird feeder area - yesterday when I exited the garage I had a red sitting on the door step looking up at me, asked him what he was doing and he took off under my shed, we'll also have several dear show up and in a couple of...

I had the electric company that sold my unit it install it and the gas company installed the tank and then did the line / propane hook up - nothing could be fired until the Fire Inspector showed up with a permit - he looked at it and had them add a brace on the line, then approved and issued the...

If your hitting the pedal with the link on / in gear and it's not moving / or not trying to move - just revs up, you are in neutral or you've got a real good brake locked on (even if the brakes were on you'd still feel it want to move) at this point with the PTO issue, I would assume it would be...

Sounds like your in neutral - check linkage - check linked pedal engagement, lever is it on, when you step on pedal does it rev the engine like it wants to move, check four wheel drive lever is it fully in 2wd or 4wd?

I use Motorcycle chan lube as well - no issues, stays on the chain - I lube after two or three storms, but in reality could most likely do it a couple of times a season as it's always looks well lubed - basically doing it for my self assurance not need.