I was hoping to install an engine block heater on my MX6000 that is used for moving firewood and snowplowing. We've had a few nights when the morning temps are below freezing and the tractor started HARD on those mornings.
My old L3560 had an engine block heater that made it a little easier to...
I needed a portable water trailer for landscaping on our farm and added a boomless nozzle to spray the road down when it gets dusty. I had an old air compressor trailer around and mounted a sealer tank that someone gave me. I have to use a generator (220V) to power a submersible well pump in...
I started welding the SSQA plate to the plow blade today. I used some old 1/4 plate and the plasma to cut out 4 pieces to tie them together.
I took your advice and kept the FEL up about 4 inches and leveled it with the ground.
It turned out the I messed up on the pricing. They are $142.50 each with a 20% discount so the price was about $230 for the set. I installed them today without any issues.
I am ready to weld on a QA plate to the plow blade but was hoping to get some suggestions on angle and attachment points. I think the best thing is to weld the plate on first then add the sides. Any comments (photos of your snow pushers) would be greatly welcomed.
I needed to order a set of wheel adapters for my Kubota L3800 since the tire chains I ordered don't fit with the current space allowance between the tire and the fender. I see they are on sale (Black Friday sale ) from MotorSport-tech for $142.50 (2 inch). Is that a good price...
I ended up finding a Browning 3TB124 sheave ( 3 groove 12.75" diameter) at a local place for $20 with the 1-1/4" bushing already in it. I ordered a 3TB34 sheave from Amazon for the fan assembly ($75 with the correct bushing). I think I did the calculations right to get the fan rpm to the...
I straightened out some of the metal and reinforced some of the welds. I added some reinforcement to the bottom of the frame and reassembled it for fit-up. I'm waiting for the replacement bearings then I can put it back together and work on the pulley setup. I welded on the mounts for the...
I used a site on the internet to calculate pulley size and rpm. I think the max speed is 2100 so the calculations come just under that. I welcome any comments.
I'll try that. The other side took a little time but I finally got it loosened up. I plan on replacing both bearings during the reassembly. Is there a good place to buy them?