I have a rock drill - its air powered. Its on a drill mast of a mini excavator with a hyd motor powering the chain applying pressure on the drill bit forcing it into ground.
The oil flow control to the mast chain motor is through a Prince flow control valve with relief valve, oil from relief...
Does anyone have experience with the clamp on electric meters.
It is a voltage meter but instead of two wire leads the wire is encircled in a clamp that opens to enclose the wire.
I am thinking of purchasing one to use in finding electric problems when lights on the truck and trailer are out...
Looking for a new cell phone.
The only towers in my area are Verizion network.
Other towers are too far away weak signal strength.
Is there a cell phone that works - that you really are satisified with?
That you can hear the voice clearly?
Do you use the fancieeee options on cells phones these...
Hello
Need to cut off a 30 inch diameter wide culvert (it's too long) thats all under water; two feet of water covers it.
I can not use a battery powdered sawall under water.
I do not want to dig up the whole culvert and distroying the road bed to cut off 12 feet.
Any suggestions?:confused...
Wondering what the available excavation construction work for this years construction season is looking like in your area?
The bids that you have been bidding, has the low bider been buying the work?
It's very quite in the upper Midwest, what bids there are; are being bid very low in price, some...
Has any one kept tract of what it cost to repair the undercarriage on their skid steer crawler?
I am looking at purchaging a used CAT 257 or ASV 70 or Bobcat T190.
I have read many posts but have not noticed any that give a review of what the parts (rubber tract, rollers, sprockets) cost divided...
I need to build a ripper tooth for my excavator.
I am thinking of using a consumed CAT D10 dozer blade cutting edge for the ripper shank it is made of DH-2 steel which has a hardness shore of 45 to 55.
I could also get a used dozer cutting edge for D10 of DH3 steel which has a hardness shore of...
I am in the final planning stage ( drawnings-specifications-components) of a small gravel screen plant. The engine I want is a 12 to 13 HP with 18 to 22 lbs torque.
These engines can come with the expensive option of the 6 to 1 gear.
My question is what does the 6 to 1 gear do? Other then...
want to install a hydrolic oil temperater gage on the machine.
what model and make would you suggest?
should I install it on the return line to the oil resourve tank or in the pressure line from hyd pump?
thinking of using a hyd tee between two hoses and screw the gage with 1/4 npt tread into...
I have purchased a White WR255400 hydraulic motor to power a home made rock drill and regulate the down pressure on the drill bit.
The factory representative of Kubota Tractor (the drill will mount to a Kubota mini excavator) said, the diesel engine and hydraulic pump puts out 1475 PSI at the...