Recent content by bushhog bob

Is anyone familiar with this spreader. I just bought one and with the green paint and yellow wheels, I thought it was a John Deere until I pressure washed it. When you pull the handle to open the slide on the bottom it moves a pointer on the side where a faded flow chart is. If anyone is...

Here are the other pictures. Started another post and hope I am not duplicating this too much.

Here is picture of inside of McCormick No. 7 and also the Ezee Flow Drop Spreaders. Chart is for Ezee Flow. I would like to find a good chart for the McCormick No. 7 Fertilizer Distributor and a Manual for it also.

Got a picture of the McCormick No. 7 Drop Spreader putting out the ag lime. Last month I found an old Ezee Flow drop spreader in Alabama that was not rusted too bad. Sandblasted, primed and painted it . One of my daughters painted it and my other daughter put the decals on it. That was my...

Just bought an 8 foot EZEE FLOW drop spreader. Going to sandblast and paint it. Went to a sign company to have a couple of vinyl decals made and they said they needed a real clean copy of the logo. I found a small copy on the internet, but they said when it is blown up to a large size, that...

I have rescued an old drop spreader. On the inside of the McCormick No. 7 Fertilizer drop spreader, the Chart for spreading the Seed, Lime, Fertilizer, etc. is old and not readable. Does anyone have a good copy or know where I can find one. Any help would be greatly appreciated. Thanks

I had my timber thinned and the timber trucks going back and forth so many times has the road beds packed like concrete. I would like to seed the roads with wildlife seed. Does anyone have any ideas about turning these hardpan roads into cut up soil I can plant seed in. Thanks for any ideals.

I need one wheel for a Burch Plow Works Cultipacker. The wheel is 16 inch in diameter and goes on a 1 1/4 inch axel. It has the number P27 on it. Any help would be greatly appreciated.

Just acquired an unusual 3 pt. hitch cultipacker. The faded name plate reads Burch Plow Works - True Blue model. It is close to 8 ft. wide and it has 1 wheel missing on the outsize. Does anyone know about this type cultipacker or where I might find a wheel for it.

Has anyone planted corn and then used a cultipacker. How would you do it or not do it.

Is anyone familiar with wooden bearings for old cultipacker? They are 3 1/2" wide, 5 1/2" high and 1 3/4" thick. The hole for axle is 1 3/4" diameter. It has (2) two 3/8" bolt holes. The old bearings are rotten and busted apart.

Found a 10 ft. double roller Brillian Cultipacker but it has a woobly loose wheel on the front roller. Anyone know how you would repair this or could it just be ignored and not hurt to use. Also would I need to check for anyother problems like bearings or anything else. This is my first post...