Recent content by C6rider

Today I found what appears to be a broken o-ring on a path that I drive my tractor down on the way to my dock. Nothing else mechanical goes down it. If unbroken the o-ring would be approx 4.25" in diameter and the rubber is .095" thick. Does anyone know if this sounds like a part off a BX24? I...

Used my Woods RB60 today for the first time to actually do some grading on my road. Previously I just used it facing backwards to move a little snow. I cannot believe how well the BX24/RB60 combo worked in a real grading operation. It dug into fairly hard pack and smoothed over potholes with no...

OK, I've read most of the old threads on this but can't find what I read a long time ago that would have answered this. I know there are a pair of wires under the left rear that are taped apparently for the BX work light. My question in 2 parts is 1. are they really for the work light and 2. are...

I'm ready to purchase a RB 60 rear blade for my BX24. My question is will the BX lift it high enough so I can put it in the first 15 degree tilt position to crown my road slightly. I read in another thread the BX won't lift it high enough to tilt but the poster may have been talking about a more...

Since I ordered a dolly for my BH and plan on taking it off for the first time I'm wondering how much weight I need on the rear to offset a load of heavy snow in my bucket. I do have the rears filled with rimguard and they are heavy. Think this might be enough? I also use chains on the rear...

After 60 hours mostly moving snow and stone I finally got to use the BH for more than just removing rocks and small stumps. A neighbor needed a 20'L x 3'D trench to extend his septic vent. This was my first time digging in dirt and it does take some practice. CFO won't let me dig practice holes...

I installed my new Bro-Tek wheel spacers today on my BX24. They seem to make the machine MUCH more stable as they widen the stance about 4 1/2" and are high quality and very easy to install. Why the caution? Well if you have loaded tires and haven't taken them off before then beware they are...

I have a new BX 24 which will never see a MMM. My question is when I take off the BH and attach an implement (when I buy one) to the 3PH do the MMM arms lower when I lower the 3PH York Rake or whatever? I assume they do not but can't find anything about it in the manual. :confused:

I've read the threads on putting lights on the ROPS but haven't heard this answered. According to my BX24 manual there is already a fuse position (20A) for the working light (rear work light I presume). Anyone know if this is pre-wired and where the connection is? It's fuse #4, bottom on left side.

There's an outfit that sells a 3 point 'handi-hitch' that has 2 trailer balls plus a clevis in the middle. Not cheap but not too bad. My question is they have 2 models, one for a Cat 1 3-point (26" wide) and one for a Cat 1N meaning narrow (20" wide) which they say is for BX series. If I want...

Brand new owner of new BX24. I noticed when I left the lock pin out of the BH last night it tilted back about 3 to 4 " by this am. Is that just normal or should I be concerned about something. Wasn't much of a change in temp overnight.

Hi all, After lurking around for awhile I finally broke down and bought a new BX24. Just BH, loaded tires and FEL w/hook now but I do have a DR grader I used with my Husky that I will pull now with the BX. My road is about 1/4 mile long. I already ordered skid plates and thumb from Bro-Tek...