Recent content by cajunbull61

Thanks... I think:oops: Holy crapola, makes me wish I had just ordered a new cylinder. I think I'm going to need a bigger vise

I have a 3525 with a leaking power steering cylinder. I have the seal kit, looks to have some extra parts in it, but I'm having trouble removing the nut that holds the cylinder together. Anyone rebuild one of these cylinders? Any tips on taking this thing apart?

Does anyone have any experience changing the clutch cable on a JX 60? The clutch end of the cable is sandwiched between the case and fuel cell with little to no room to maneuver. Shop manual doesn't seem to address this issue. I considered cutting an access hole in the floor, but not sure the...

Thanks for the reply. Both fuel filters were replaced within the last three months. The air filter is an oil bath system and was cleaned when the filters were replaced. We had an issue with some bad fuel a few months ago which led to the filters being replace along with the tank being drained...

We have a 3525 at work that started running rough while bush hogging. Fuel was drained from both filters and refilled and engine primed. They were unable to get it to start. I cracked an injector line and cranked it and it started, running rough, no throttle response. When I tighten the injector...