yep it only runs when the tractor is running, but on that note no other hydraulic pump would run without the engine running either., i dont know if it has a fuse. it uses the normal blade engagement switch that disengages the clutch when the key or switched to off. i dont think a fuse would make...
I just slammed this one on, I made an entire bolt on sub frame to add rigidity and just cut and welded the loader itself to fit. I'm running a 2900 psi pump off my electric clutch so I can turn it off and on to conserve power when I'm not using it. It will lift more than the tractor weighs from...
hi i have been trying to figure out how long the factor rocker arm flag brackets needs to be, from center of rocker shaft down to pushrod link hole that the pin goes thru. then how far is the hole center to center on the flags that point aft? also are those oriented exactly 90 degrees from each...