Recent content by ccsial

I have a Ford 1900, bought new in 1982. The last two times I used it I have some coolant dripping from the radiator overflow. Left about a 6 inch diameter puddle on the drive. I replaced the radiator cap with one matched up from Autozone after the first indecent and it did it again. The temp...

I have a 12" culvert, HDPE Dual wall H25 rating. I need to get more gravel over it. Right now there is only about 1/2 inch of gravel over the top. I am wondering if my RAM diesel and 12' x 6' gravel trailer could go over it to spread more. I don't have a way to turn around and I am not going to...

Wondering how many would go for a gas CUT if Kubota made one. Do all new tier 4 Kubotas use DEF?

I'm looking at getting this for a backup in case my 25KW kohler has a problem during a bad outage. Anyone have opinions about Winco generators? Winco W1PTOS PTO Generator, 3-Pt Hitch, & Shaft Package (1kW)

Has anyone heard if this saw will be available in the USA...

Does anyone know of a snow blower that is geared up to run faster than 540 RPM? I didn't find one searching. My blower on the L3400 throws snow about 15 feet and plugs easily in wet snow. I have a Honda walk behind that throws snow about 30 feet and never plugs. I feel the need for speed on my...

I stopped my my dealer today to get some oil. A Mom and Pop dealer with great service. He had three saws on the wall. This spring it was full. I asked why so few. He said Stihl now requires you to pay up front before you sell them and he did'nt have enough cash to stock the wall. Does this...

This isn't a tractor post but I am wondering if anyone has seen a hornet this big. I killed one in my tractor garage last week and this one showed up today on the screen of my cabin. I wonder if this is one of those Asian hornets. I have never seen one near this size until this year. I am in...

Just bought a 150 TC-E to leaqe on my quad for cleaning up stuff that keeps falling all summer. Sure is a super light saw for those little jobs.

Just wondering how many hours and what problems you have had on your L3400. Mine is a 2005 bought new. It has 360 hours on it. It is used with a Woods RD7200 finish mower and a snow blower. I have no end loader on it. Almost all the hours are with the PTO running. My dealer replaced the 3PH...

The last few times I enaged the mower at idle it was a bit jerky starting up. Today the cable broke off at the lever end. The cable must have been hanging on by a few threads and stretched towards the end. It lasted 368 hours and seven years. I called four dealers near here and nobody stocks...

I've had my 2005 since new and never really noticed that the HST pedal has play in it. I noticed the pedal is loose on the HST control arm bracket, but It does not tighten up. It may have been this way since new. So, are your pedals loose or tight to the HST control arm?

I have not changed my profile since the new forum format was installed. I can't figure out where to change my profile. I am logged in, I guess I'm getting stupid. Need help.

I sat on an L3200 today and while there is a slot for the cruise conrol lever, there is no lever. Did the dealer not install it or is it an option now?

I went over to the farmer across the street to clear a drift on his gate he couldn't get with his back blade. There was a tree branch in there so I broke a shear pin on the impeller. Normally no big deal. I drove back to my garage to replace the pin and found the impeller was jammed. It became...