Recent content by cgarai

  1. C

    Bobcat 331 Temperature sender

    I have a 331 s/n 232511798 with a Kubota V2203-E engine. The temperature gauge rapidly rises from cold to hot and then the motor shuts down. I know this is not an actual overheating problem because this will happen with the engine cold and barely warm by the time it shuts down. Does anyone...
  2. C

    Austin Western motor grader steering problem

    I bench tested the circle latch solenoid and it seemed strong, but it doesn't open the latch. I should have jiggled the circle control and it would have popped up. The problem is that the teeth on the latch are tapered and with load, grease and vibration they pop up out of the circle teeth...
  3. C

    Austin Western motor grader steering problem

    I believe it must have a gerotor because the only connection to the front end is hydraulic. When the power is off I can turn the steering wheel and the front wheels slowly move. The feeling is bumpy or jerky which I'm guessing is the pulses of the gerotor? When the engine is running it feels...
  4. C

    Austin Western motor grader steering problem

    H I just picked up an AW Super 300 grader. Serial number 366 16470. I have a couple of issues I'm trying to sort out: 1. The steering is very stiff and "jerky". By jerky I mean the steering wheel feels jerky when trying to turn hard. This does not translate to the front wheels. The system...
  5. C

    331D Excavator with dead hour/rpm display

    Hi, I have 2001 331D s/n 232511798 that has a dead LCD display. This display only shows hours and RPM. It is a segmented LCD display, but none of the segments are working. The rest of the instrument panel seems to work fine and the machine operates just fine as well. I've taken the...
  6. C

    JCB Sitemaster runs for 10 minutes, then starves for fuel

    Hi, My 1991 JCB Sitemaster backhoe is having a fuel delivery problem. I can't tell if it is the fuel solenoid, the lift pump or the injector pump. If left alone for a day or two it will run for 10-15 minutes and then start to bog down and then stop. Sometimes manually operating the lift pump...
  7. C

    Replacing an oil pressure switch with a pressure sender. Should I ditch the switch?

    Installing an oil pressure sender on an Isuzu diesel generator to interface with a controller. To do this I have to replace the oil pressure switch with the sender. The controller can shut the engine down for either the switch or the sender signal. Or I could have a belt and suspenders by...
Top