Recent content by chipslinger69

It's been a while since I have updated this thread so just to let everyone know that the project didn't fizzle out here are a few updates. I received and installed the PTO parts that came from a Mitsubishi MT372. The difference between the two is that the MT372 has a one way clutch and you have...

A little update. I replaced the seals in the rear axle housings and got them reinstalled. The hydraulics are not bolted down because some pto parts that I ordered should be here tomorrow. I'll get them installed and bolt down the hydraulics. I have the seals, bushings and bearing ordered for the...

A little update on the $300.00 "Mitsubishi/Kumiai ST1540" project. As usual, the 4wd problem was the pin had fallen out of the shaft so the shifter did not have anything to engage. Found pin and permanently replaced it. Got the tractor mostly stripped down and rear seals ordered. I did not opt...

First off, hello everyone. As you can tell from my post count, I am new to this board. I live outside the big city of Bryan, Tx. I have been around tractors most of my life. Mostly in the hay fields. I recently acquired an old 1979 Kumiai ST1540 with he K3B diesel engine. When I purchased it I...