chrismac's latest activity

Got this issue fixed tonight the o-ring on the HPCO adaptor had been nipped during assembly and that was the leak path to the return...

Your correct, when I disconnect the return line to the tank, the 3 pt linkage works as it should, strangely the loader also seems to...

Thanks I will do and report back, if I block the out port, I gather I am then forcing oil down the HPCO as thats the only route out...

I did the same thing on my Rexroth valve for my loader valve. While it was drilled and tapped for the Carry over or Power beyond port...

The leaking loader spool valves have been fitted now for some time, I went back and fitted the replacement set bought and after...

My tractor has a 3 speed pto. 540, 750 and 1,000 rpm. All at 2,200 rpm. I put a tach on the shaft to figure out the engine speed to get...

My bolens/iseki tx2140 runs just under 540 PTO RPMs at 2600 engine rpms in PTO 1. It has a small red dot on the tach that I presume...

There are some mighty inexpensive digital optical tach's on Amazon and eBay, which will serve you well. Stick a piece of white tape on...

Its been a while, I have an analogue taco, but it does not read in reverse:( (the direction the pto shaft spins) if I remember correctly...

Thats interesting, I thought gear 1 was 540 pto speed. maybe this is why my finishing mower is not cutting 100% although its doing a...

Someone asked elsewhere about engine speeds against PTO speeds, so.... I've just been and tested my TX2140. These readings will give...