Yeah it’s the 24HP Kohler. I found a small melt spot on the jacket where it contacted the valve cover. So I’ll see if I can get it to stay above there and then down to the carb.
Thanks!
Hi all
I'm looking for some help with my 2014 LTX 1050. Replaced throttle cable in March but now binding so badly it bent the bracket where cable attaches.
Was able to get it moving again with WD-40 and straightened bracket. Carb linkage is fine.
Now next day it's bound up again.
What might...
Good tips. Fortunately access is ok.
I may have solved the mystery. I followed the time-honored technique handed down from my father of “look at the other side, dummy”
They put an oversized line on the problematic side, they must’ve clamped the end on after feeding the hose through. The...
I have an early 2000’s Cub Cadet 408 backhoe with blown stabilizer line. They thread through hole in frame but it seems too tight to get out without cutting off fitting. What am I missing?
Hi all
I have a 1999 7305 with 408 backhoe.
the larger of the two hydraulic lines on the right side stabilizer is damaged and leaking. It is one of a pair of lines that runs through a hole in the frame between the control block and the cylinder.
I don’t see any way to get the line out to...
I have an LTX1050 Kohler and just completed my first oil change. And cleaning up afterwards - what a mess.
The plastic drain plug wouldn't pull open and turning further caused the whole drain plug to come out, spilling oil everywhere. I think I got it in tight enough (no leaks) but want to...