Recent content by cjah

Does anyone have a Ford 3910 wiring diagram? Recently picked up a state owned unit and they replaced the headlights with blinking caution lights. Want to convert it back to headlights that wont blink. Nice safety feature, I guess, but where I use it there is no one there to see the blinking...

My tractor start leaking fuel badly at one of the injector connections. I know next to nothing about injector pumps and was hoping someone could tell me if this is a simple fix. This photo is the overall setup with injector and filter It started leaking at this point where a plastic...

Bought a 3910 that needs a complete 3 point hitch setup (lift arms, leveling arms, and stabilizers). Would like to find a complete setup off a salvage tractor, but not a lot of 3910's in the scrap yard. Are there any other models that use the same 3 pt hitch system or do I need to look only...

Hello Ford 3910 owners...hoping you can help with a question: How wide is your 3910 at the rear tires (outside dimensions)? Tractor data is showing 69" but that seems a little narrow to me. I looking at picking up a 3910 and wanted to make sure it would fit between the fenders of my trailer...

I appreciate all the great help I get on this website, so following up with some photos and notes: - First step was to drain some oil. I got a couple of 5 gallon buckets from Walmart and drained 8 gallons which brought the fluid level just down below my PTO shaft. The 1st photo shows the...

Need to replace the PTO seal on my Ford 5610, but was told if I pull the PTO shaft I would have to break the tractor in half as a thrust bearing would drop when I pulled the shaft. Does anyone know of an easier way to replace the PTO seal? Can it just be picked out from the rear without...

Hello from GA. New member that likes just about any tractor, but leans toward the blue ones. Still got a lot to learn on fixing them and grateful for this forum. Photo of my tractor attached. Picked this up off auction and just finished adding a used loader. Now I just have to learn how to...