Recent content by CJinNH

Yeah I went there and ordered each part one at a damn time... was hoping there was a maintenance package, I guess my ADD got the best of me. Still $200 for just the basic bearings and seals.

yep, gear box is empty and will not hold fluid

The seals failed in the center spindle and then the bearing. I have watched several vids showing if you're replacing the center spindle bearing you should do the ger bearings while you're in there. I can find the kit for the RCk60 23BX, curious if it's the same bearing set for the wider mower.

I have a BX23s with a RCK54 23BX mid u mower. The bearings are shot and I'm tryng to buy a gear box rebuild kit with all the bearings and seals needed for a routine bearing swap. I've found several that are close, but none are numbers correct. Can anyone point me to wear I can get this kit...

My BX23s backhoe has a leak low in the bottom of the arm... I use it so infrequently I haven't bothered to fix it. The FEL has no issues, once in a while it will squirt a bit when removing, but other than that she's good.

I got my BX23s last year, thumb, 3 pt hitch, 54" mower, back blade, bucket blade for $23,000ish

I am going ot use my BX23s to clear snow this winter and figured I should add some lights on the ROPS. I didn't want to modify the ROPS in anyway, so I used the foctory holes and $100 in stainless bits to install the 4 LED's. I faced 2 forward and two back. I used 1" rare earth magnets and...

Bought my new BX 23s last month, it came with the 54" Mid mount mower. I have a long swail on one side of my lawn that has a bit of a pitch and wanted to get some wheel spacers for the back wheels for a bit more stability. I saw all the online higher end wheel spacers, but also read about...

She's home

Hello, I was once a member here years ago when I owned a MF 1428v I bought back in 2004. A divorce and a lifetime later I'm back in the market for a new tractor. When I had the 1428v I had 4 acres and after time, I thought the tractor was too big for my needs. It mowed well, but I wasn't a...