Recent content by CorporateOffRoader

Maybe 3 times over the last 6 years that I have owned this tractor, when I started it up the motor has been excessively loud. Dieseling like it was going to explode, then smoothing out maybe 30 to 40 seconds later. Seems to only do it when it is below 45 in my heated shop, and only once in a...

It seems that after using the tractor for awhile, after I park it in the shed there appears to be maybe 1 or 2 drops of hydraulic fluid that drops off the seal on the steering ram. I wiped it all off and then let it idle for awhile, turned the wheel back and forth several time and while the...

I had the dreaded wheel seal leaking issue last weekend, after reading up on the fix here on the forum, I tackled it myself. Success, in fact, much easier than I anticipated. I utilized my 20 ton Harbor Freight shop press and once I figured out what to use support the hub, it all worked out...

I use my 3320 to move my 35' - 8,000 lb camper around and get it into and out of my shed. The door is 12 x 12 and the trailer is 8 x 11.5, so it takes the maneuverability of the tractor to get it in. Also doesn't help that the driveway is only 35' from the door, so a sharp 90 degree turn to...

The momentary contact operation of my cruise control switch is no longer operational. 5 months ago, it was not making contact so I disassembled the switch and filed off the end of the plastic rocker so it would make better contact on the switch parts. That has now failed again, does anyone...

Yep, I am 90 miles east of Minneapolis in Eau Claire, also have a pile of snow at the edge of the driveway (actually several piles up and down the drive). My 3320 has been a trusted friend this year!

I picked up a used 3320 yesterday with 654 hours on it for $18,000 with the loader. I had the dealer install a 300CX FEL on it as it was without one on the lot. Seems they didn't top off the Hydraulic fluid after installing the loader. The level is about 1/4" up the dipstick, any...