Recent content by Damifino

Classy Enough?

Ahh? thread after my own heart, this was driven by the covid virus. I was seeing more and more rats and mice than usual, more than likely the new neighbors have horses and with the feed?ere they came. I have the top lined with galvanized and a pedestal in the middle also lined with galvanize...

:laughing:

Looks like you overlooked 1 more accessory to the ROPS.

That comment So reminded me of National Lampoon Vacation...

Got the pcb out, the connector from the pot plugs in as shown, no values shown that I saw.

The pot is in 2 pieces, don't think I could get an accurate read as the inside is pretty messed up, judging by how thin the copper inside, I would have to agree with you being low wattage.

:laughing: I know guess how many views vrs replies, I have a Delta GR450 bench grinder. I purchased new and liked the variable speed control. 1725 - 3450 rpm. Went to sharpen some tools and it ran at 3450 or higher, when I try to adjust speed control, no difference. Took it apart and the pot...

I just think you are over complicating the issue, my wife understands that it can be rough at times and does all she can to help.

Looks like this could be adapted for your drill press.

Here is what I use. It's made by Rectorseal and is called a 2"twister, as shown in with it inserted in drain, it passes through drain ans has a o-ring seal. When you tighten the orange knob there are teeth that expand to grip the pipe. Edit to show out of drain

Hello Pack, just had my first ever issue with my DK35, I was hooking up a trailer on 3 point, left motor running, then I heard it sputtering ran over to turn key off. The fuel gauge showed ｽ tank and when I removed fuel cap and put flashlight in tank, it was bone dry. To date here is what...

It's going to be a tough week this week, I think I will make it though!!!

I have read alot of posts concerning water getting into ignition switch, I have come up with a simple solution to keep the rain water out if yours stays outside. It consists of a 1" pvc pressure cap and a short piece of 1" Thin Wall Pipe. This fits snugly on my 2008 DK35, hope it works for you...

As pine stated, make sure the offset flange has adjustable metal ring so you can offset left or right not just front to back