Recent content by Danger18

Oh, and it’s an xr4046, not 36

Now I have to check the air pump. This could be the cause of my often and long regens as well.

No codes. I actually think it has never worked since I bought it used 7 years ago. I’ve always thought the tractor lacked power. Doing some reading. The ecu, fuel pump and air pump are on the same fuse (#9). Checked that fuse. There is a 10 amp use there where a 5 amp fuse is specified...

2015 LS xr4036hc problem: electric fuel pump does not operate with ignition in on position, nor after starting. Disconnected the fuel pump and applied 12 volts to the pump with a portable battery and it operates. Checked the power source wire connector and there is power there. I had already...

I couldn’t find the nomenclature of the rear couplers in the service manual. I’m getting ready to order hoses/couplers online as well. Just mounted my new Danuser fork grapple, and can’t find the coupler listed in their operator’s manual either. Anyone recognize these?

This looks uber useful. Multi-Purpose Grapple | Danuser

Getting out - Brazilian Construction

Here's a pic of another member's mod to his dog legs

Here are photos of the pto valve that I replaced. Apparently the loose fit of the solenoid on the shaft allows dirt or other debris in and this is the result. Does anyone know how snug the retaining bolt should be behind the solenoid. Only evidence of a short in the solenoid was a small bump...

After searching the LS parts manual for the LL4102, I cannot find a part number or spec for the grease zerks that are used on the FEL. I've broken 3 trying to get my grease gun off. I've tried loosening the fitting on the gun.

Tie rod broke off while backing up a steep slope with the hog attached. How can I get the casting off the ball joint without tearing up the rubber boot? Heat? Fork? Trying to avoid taking the one side apart in order to put it in a vice and pound it out.

While crossing a fairly steep ravine, to see if I'd be able to cross with the bush hog attached later, I bottomed out pretty badly on my 3 point lift arms that I had left down when I dropped off the bush hog. I heard a loud report, which I shrugged off when it climbed right out. I later found...

While crossing a fairly steep ravine, to see if I'd be able to cross with the bush hog attached later, I bottomed out pretty badly on my 3 point lift arms that I had left down when I dropped off the bush hog. I heard a loud report, which I shrugged off when it climbed right out. I later found...

Thinking of dropping my fuel tank to empty and clean it. xr4046hc with 225 hours. Three weeks ago I got a light indicating water in primary filter and drained it. Light went out right away. That is when my regen problem started. On the next regen, it just stayed in regen for about 6 hours...

Compression. Fuel pressure. Hydraulic pressure. I'll be going out of warranty with less than 300 hours soon, and am wondering what else I should have inspected prior to 2 year warranty expiring. I have a 2015 xr4046hc. Only somewhat common issue I've seen on here is the hubs which seem...