I have a Ford 2810 that has a line leaking where it attaches to the pump. It's the line that to the far right, in the center and is a flared fitting. It had a yellow substance on some of the threads and I though that might have been the remains of some kind of O-ring. I cleaned it up and...
I started a thread about if aftermarket diesel injection pumps are any good. I then found D&C Diesel that rebuilds pumps for a good price. I'd rather have my pump rebuilt over a Chinese aftermarket. That is if it's affordable.
Does anybody know anything about them? I could only find one...
I have a 2810 Ford and the injection pump isn't working. I took the top off but can't get the metering valve unstuck. A reputable diesel service said to rebuild it would cost from $700 to $1,200. I can buy a new aftermarket pump for about $600.00. I'm fairly certain that it is a Chinese...
I have a 2810 Ford with a CAV injection pump. Fuel comes out of the bleeding screw on the pump but none comes out of the lines to the injectors. After a lot of reading I suspect that the metering valve is stuck. I tried tapping on the housing while the throttle was wide open but it didn't...
I started a thread in another forum and haven't had much luck so I thought I'd start one in the Ford/NH forum. I have a Ford 2810 (approximately 1988 year) that's not used a whole lot but now that I need it to haul wood it doesn't want to start so I decided to put a frost plug heater in the...
I've came to this site plenty of times for information but never joined because I always found what I needed. After much searching here and other places I can't find what I need to know so here I am.
I have a Ford 2810 (approximately 1988 year) that's not used a whole lot but now that I need...