With 760 hrs.on my Bx I have noticed a distinct Vibration when running in AWD.
It sounds similar to a bad U-Joint back in the day at highway speed.
It appears to be coming from the front rear (that doesn稚 sound like it makes sense 貿ront rear).
At any rate, at speed it vibrates thru the whole...
Well any help would be greatly appreciated. Here you go. When sitting still and a load on the bucket, I cant help but notice a distinctive clunk while turning the steering right to left. It almost sounds like a bad inner tie rod end or a bad steering rack. When I put my hand on the front axle...
I need to change the HST cooling fan on my bx2230. Does one gain access by removing the floor board or is there a way to wrestle the fan blade in from underneath? Is the splined coupling on the trans output shaft pressed on where you need a puller to remove it or does the fan fit over it? I...
I am trying to get a reading of the hydraulic system pressure on my BX2230.
Should it be measuter after the FEL control valve or before?
Obviously I am not sure were to attach the pressure gauge. There are three hydraulic lines that come up from the Rt. side of the engine shroud, lower by the...
Does anyone know were I can get the shims needed to increase the front loader hydraulic relief valve pressure.
I called the dealer about them for my BX2230 and he told me he knew nothing about shims. When he looked up the illustration of the valve components, he said it showed no shims at all.
I知 thinking of buying a rear mount mower for my BX.
I see one on line for sale. The thing is I never herd of a 斗ynx .
It is some kind of Chinese brand. You know, its cheep & brand-new.
Anyone ever herd of it. No web site that I can find. But for $700.00 from a private owner, a 48 in finish...
What kind of results can I expect from a 4 ft XB Rotary Cutter attached to my bx2230? Will it cut just fine grass? I don稚 really have any brush that needs to be cut up just about an acre of weeds & sand.
I really don稚 want to spend the extra money on a MMM. I just want to knock the grass & weeds...