Well it's a done deal, Bx is back up and running. It was an easy fix and anyone can do it. The best part is that no fancy tools are required, although I used a lathe to remove the center section a hot knife would do the job as well and any sharp chisel could be used to remove the leftover fan...
Well here I sit with a busted tractor fan and the dealer won't get another one in untill Monday so what to do?
Well yesterday I took the roll bar off of the tractor as that was the easy part and if I had to pull the tractor apart I might just as well start there. After I removed it an amazing...
Ok so today I trashed the transmission fan on my BX2350. where do I start on the replacement? what I mean is what is it that I have to do to get the old one off and then put the new one on? And before anyone pipes up about a skid plate, yes I have one from bro Teck but somehow a stick found it's...
I have a problem with my BX, it loses power for no particular reason, I can be mowing along quite nicely and then it will just bog down almost to the point of stalling and then after a few minutes it will just fire up again. It has to be a fuel problem but I don't know where it would be, both...
Didn't plug my bx2350 in last night for more of an experiment than anything else. I went out to start it this morning and gave it around 45 seconds of glow time. It turned over slow but it fired up, stalled, a little more fuel and it fired up again and kept running. It ran rough but it kept...