Recent content by demote

  1. D

    Starting Procedure

    This is a 2023 model and don't when it changed but the 2638 no longer has the glow position where you turn your ignition switch to the left. I measured the timing when first turning to ignition (not starting) and glow plug indicator turns off after 35 seconds. Once started, the glow plug...
  2. D

    Starting Procedure

    I've replaced my 2810HST with a new 2638HST and would like to know how others are starting your tractor. The glow plug initiation is different and salesman says a glow plug pre-heat is no longer necessary.
  3. D

    Horsepower Upgrade

    I am looking to trade my Mahindra 2810HST for more horsepower. My 15KW pto generator got me through hurricane Irma just fine even though it specs requiring 32HP. May not have gotten fully loaded but still want that capability. Additionally, considering a tiller which requires 35HP. I don't know...
  4. D

    Mahindra 2810HST Battery Replacement

    Can someone please tell me the correct battery replacement for a Mahindra 2810HST? The parts manual and owners manual are not very helpful. Thanks in advance!
  5. D

    Mahindra 2810HST Stops Running

    My Mahindra 2810HST stops running randomly. When I hit the brake it will continue to run. When I release the brake it may or may not continue to run. Anyone experienced with this issue that might give me some advice would be greatly appreciated.
  6. D

    2810HST/TYM Equivalent

    Anybody know what the TYM equivalent of the 2810HST is? If so, do you know if they are identical or did Mahindra make certain changes or variations? Thanks in advance. Danny
  7. D

    2810HST Modification

    I recently found out that Mahindra had a modification whereby they added a relay mod into the wiring harness in order to eliminate a voltage backfeeding through the control module and burning it out. My machine is two and a half years old and this was my dealers first instance of this but I...
  8. D

    2810HST Not Starting

    Your suggestions please. The tractor has been cranking fine all weekend but the last time I shut it down and went back to crank it, it just failed to hit the starter. I've jumpered the seat switch and tested the brake switch, pto is off. I hear clicking but no attempt to turnover. It acts...
  9. D

    Diesel question

    This may seem like a dumb question but I'm a little new to diesel engines (previous tractor was gas). In another forum, someone mentioned that they use gloves when pumping diesel and I just passed it off as for the fact that diesel stinks but I suspect there's more to it. I often, when nothing...
  10. D

    When do you start with glow plug?

    My manual says to start using the glow plug to start the engine at 23 degrees F but the tractor seems to crank so much better when using it even though it's warm weather. What do you guys do?
  11. D

    Mahindra merchandise came today

    In case some of you haven't seen this site (I hope I done that right), I ordered a couple Mahindra caps, a shirt, key ring and coolie. I got two different styles of cap. One is referred to as the ag style, it has mesh panels and the other is solid and low profile. They're better looking than...
  12. D

    Mahindra MMM

    I have yet to take the MMM off my 2810HST but I'm deliberating over the possibility of lifting the front wheels with a hoist and hopefully rolling it out from underneath. It seems like this would make it quite a bit easier. Can anyone give their experiences in the matter? Danny
  13. D

    Backhoe  2810HST Backhoe Addition

    I thinking about adding a backhoe to my 2810. Anybody know if the Mahindra 3265 backhoes can be added when a Mahindra MMM subframe is installed?
  14. D

    Sub-soiler/Middle Buster

    I thinking of purchasing a combo sub-soiler/middle buster. link My immdediate need is to bury some cable but it seems this combo unit would be useful. My question is will the middle buster serve as a plow or am I misunderstanding the use of this implement? I would appreciate any input. Danny
  15. D

    2810 Tiller Size?

    Okay, I'm gettin' spring fever and don't have a tiller. The footprint of the 2810HST is around 64" or 66". So who's got what and what are your suggestions? Thanks in advance. Danny
Top