Bought a tractor and it is missing the top link for the 3 point. I am wanting to pick one up but i am not sure how to determine the length i need. Thanks
I am looking at a box blade that has hydraulic actuated rippers but my tractor doesnt have any rear hydraulics. Is it possible to add them and if so how? Thanks
Well i think i found one that will work for me and its in budget at $900, its a used Cammond industrial 2C2 6' which according to their website weights 860 pounds. The only problem with it is that it has hydraulic actuated ripper teeth and i currently dont have any rear hydraulics. I am not even...
I am wanting to get one or the other but cant afford both. I do not have a lot of driveway to maintain but would like something to keep on the back of my tractor with a front end loader. I am not sure which one would give me more bang for my buck or which one would be all around more useful...
I messed with the 3 point for the first time today and figured out the shorter lever on the RH side will raise it but when pushed all the way forward it doesnt seem to make the 3 point go down. The 3 point just "settles" slowly on its own and doesnt seem to want to lower all the way even when i...
Somewhere i seen a clamp on receiver for a loader bucket that had 2 clamps instead of one. It appeared that it would spread the load better than a single clamp on unit. However i cant find it again and was hoping someone else may know what i am talking about and can point me to it. Thanks
Is there anyone out there that makes a bucket mounted push bar? Something that would work for pushing around non running vehicles etc. Or has anyone made something up for themselves? Thanks
I picked up a MT4201FD and i am in need of manuals for it but not sure where to get them? Also are there any salvage yards for these tractors as mine is missing the 2 side fairings. Does this model have glow plugs and if so how do you activate them? Its really cold blooded and you have to give...
I just got my first compact tractor, a Mitsubishi 4201D that has a pin on loader bucket. I am not wanting to convert to a quick attack system so i need to get some bucket forks for temp/occasional use. I would like the chain on type but i do not know where to go to get a good set. GC...