Recent content by DenisM

I have a ZD-1011 Zero Turn and had a question about greasing the "U" joints for the shaft that goes between the motor and hydraulic pump. Was able to get the slip joint fitting and the "U" joint on the motor side. Seems impossible to get to the joint on the pump side without removing the shaft...

Tried that; didn't come up with anything.

I have an older 4530 with Mahindra quick attach and bucket. When I first bought the tractor new around 2003, it had a stock bucket level indicator. Took it off because I was doing a lot of clearing work and didn't want to damage it. Cleaning up my shop today, I found the indicator and wanted to...

Found a nice, clean ZD1011 with only 85 hours so I bought it. Fellow is bringing it early next week after the holiday traffic dies down.

I moved it to my place on an equipment trailer. Steel beams weigh maybe 2 or 3 thousand lbs not really sure. 2 ton electric hoist.

30' x 25' around 10' high bridge crane. Now in pieces so it can be moved. Can get help to load onto your truck or trailer. 410-905-0432.

Looking to buy a new diesel zero turn mower and have always liked Kubota equipment. Two local dealers I called gave very vauge answers to my engine questions. Do the smaller zero turns, like a ZD 1011,require DEF? Do these smaller engines have an EGR system? Do these smaller engines have a...

I have a BX-1500 and the valve stems on the front tires are dry rotted and starting to leak where the stem goes through the wheel. Anybody know the wheel hole size for the stem or the trade number for a stem that fits? I would like to have a new stem in hand before I remove the tire. If the stem...

I was thinking about getting a front mount snow blower. The one I was looking at requires hydraulics to make it work. It is driven by the mid PTO; but needs a joy stick to lift it. I have a load but the joy stick is attached to the loader. So when the loader is removed, the joy stick goes with...

Any body with a BX-1500 have a snow blower? Am seeking some info before I decide what to buy a blower. Front vs rear mount? Brand? Cost? Width of blower?

I have a BX 1500. Today when I started it up I noticed my head lights were on but the switch was in the off position. Turned the switch to on and the lights went off for a few seconds then came on. Turned the switch off; the lights went off for a few seconds then came back on. Any ideas what's...

I have a 20" Homelite Chain Saw that was a reconditioned unit. The saw does not cut straight. My other saws give a nice square cut; but this Homelite drifts and will not cut square. Any ideas what causes this?

The hour meter on my 4530 has a space to the right of the tenths of an hour digit. The space has a wheel which moves between black and white. What is the significance of this wheel??

I would like to install LED lights on my trailer; but am concerned about the turn signals working properly. My concern is the truck flasher unit. I have a '97 Dodge with factory installed tow package. Anybody know if LED lights will work with my truck?

Have a Mahindra 4530 with a Mahindra loader. Problem is Mahindra's only come with a 4 position control from their loaders. Which means you can not raise and tilt at the same time. Any ideas about how I can convert over to an 8 position type control??