I have done alot of reading on the topic TNT and still not sure on what I need and how to install it. I'm going to put it on a japan made tractor. First of all what size cyclinder for top and for tilt and does it matter on pressure. I want to use a toggle switch instead of control valve because...
Does anyone know how to check glowplugs to see if they are bad. I turn on the switch to heat them up and nothing happens there is 12 volts at the plug but no heat. I checked the plug with a meter and theres no conection between the two ends. Its so hard too crank when its cold I'm afraid that...
Does anyone know how to check glowplugs to see if they are bad. I turn on the switch to heat them up and nothing happens there is 12 volts at the plug but no heat. I checked the plug with a meter and theres no conection between the two ends. Its so hard too crank when its cold I'm afraid that...
I am new at this so maybe you can help me. I have a Shabaura D28F with FEL and BoxBlade. What do I need to dig ditches on a driveway? I was thinking of a scrape for the job but wasn't sure that there wasn't something else that was made just for digging ditches.
Has anyone had any problems with the 4x4 making a poping sound and the front wheels jirking then the problem just goes away.Well I was moving some dirt yesterday and I was about done and I made a few sharp turns and the problem started I straighted the wheels a little and it stopped after a few...
Well I have run into a problem.I have bent my side arm twice now the first time was by pushing a stump backwards it almost made a horse shoe.I had it bent back by a press but the guy that did it bent both ends straight too and I had to take the other one off and take it back so he would have one...
I know I'm full of questions but as you can tell I'm new at tractors I'm wanting to learn more.I was using my box blade the other day and after about 3 hours of hard work,I was about out of fuel and figured it was time to take it back to the house.While on the way I was pulling a hill with the...
Does anyone know why my PTO shaft doesn't turn when I turn the switch on?The switch is located on the dash and if you keep playing with it by turning it on and off the shaft will start turning.If you turn the switch off for a day then turn it back on the shaft doesn't turn.I'm guessing that the...
I have a problem when I put my turn my tires on the outside and I turn my tractor sharp right or left it hits the bottom side of my loader and binds up.My loader is a Allied 295.If I leave my tires turned on the inside I have no problems but everyone knows that if you want more stability they...