Hey again everyone. I am doing a new frame and reusing the axles for my Kubota Hauler. So wanted input on what I would need as far as steel and see if maybe someone has an old set of plans I can look at. Not trying to be cheap, just don't want to buy a set if I decide to not go this route. Also...
Ok, need expert advise. I've acquired a 31' travel trailer that had extensive water damage. I have stripped it down to the frame. It has 10" I-beam main beams, 4500lb axles with brakes on both and should fit the bill nicely for a tractor hauler, GVW is around 9k. I intend to weld up a square...
I am trying to get the size oil change valve I need for my JD 320. It has the FD590V engine. I just put in full synthetic and really don't want to drain it back out. I backed it out a few turns and put my micrometer on it and it came in at 18.5MM but I couldn't get the thread part. Not even sure...
Hello all, I'm a proud new owner of my first big tractor (only had old Cub Cadets before) and couldn't be happier with this beast. Only put a couple of hours seat time in so far but I'm amazed how I've lived without it this long. I accomplished more in about 2 hours on some overgrown land than I...