DJ54's latest activity

  • D
    Might look around for a local diesel repair/supply business. I'd think most could get them with no problem. Also found some aftermarket...
  • D
    DJ54 replied to the thread 2022 gardens.
    Finally got my tomatoes, peppers, and cotton mulched last week, when we got a few cooler, and dry days. At least one less section of the...
    • 20220802_204356.jpg
  • D
    DJ54 replied to the thread Case 1835-B.
    Probably going to need a service/repair manual to get the diagram. Did a quick search for a 1835-B service manual, and more than several...
  • D
    DJ54 replied to the thread Pulverizer Pins.
    Rebar may be a bit soft for that, even though it is 3/4". Those teeth are just spike harrow teeth, and you should be able to find them...
  • D
    DJ54 replied to the thread Case-IH 265 offset gr.
    Call these guy's, they are in the heart of cultivating country. BURCH STORE TRACTORS-VINTAGE SALVAGE YARD,NEW AND USED,TRACTOR PARTS...
  • D
    DJ54 replied to the thread Case 430.
    Looking at the Case/IH online parts book, the 430 came with 16" rims, but different width's. Schematic, Manuals, Specifications and...
  • D
    DJ54 reacted to Chriswt314's post in the thread Backhoe lines - can’t get through frame with Good Post Good Post.
    Good tips. Fortunately access is ok. I may have solved the mystery. I followed the time-honored technique handed down from my father...
  • D
    DJ54 replied to the thread Rennovating a garden.
    I too use leaves as mulch around set plants. Just leave them lay over the winter, and plow down in the Spring. They will pretty well be...
    • DSC01061.JPG
  • D
    Most hoses have a male/female ends, with the female/swivel end being larger. Male non-swivel threaded end should actually smaller than...
  • D
    DJ54 replied to the thread MF 180.
    It may not be that the power steering isn't working, but rather the bearing on the steering shaft just below the steering wheel, under...
  • D
    DJ54 replied to the thread Case 480ck crank pulley removal.
    The nut is a RH thread. Heat until the nut until it is nearly orange, then let it cool, so as not to distort that 1/2" square opening. I...
  • D
    DJ54 replied to the thread brake diagram.
    I didn't realize the VAC had 3 different series, within the same years built, and not sure the difference. Here is a link to the Case/IH...
  • D
    Here are a couple links to the Case/IH online parts book, you may find come in handy, looking for parts for various function groups on...
  • D
    DJ54 replied to the thread Case 480F Brake issue.
    Your 480F brakes are a different animal compared to my 480C's brakes. It appears the slave cylinder on yours looks to be stationary...
  • D
    DJ54 reacted to 480Fman's post in the thread Brake reservoir full but no pedal with Good Post Good Post.
 
Top