Dmacleo's latest activity
-
Dmacleo replied to the thread GC2600 whining gone, then came back.should suck DOWN with eng running. least my 2400 does, manual says too check level fel down, bucket curled down UP (edited to correct)... -
Dmacleo replied to the thread GC2600 whining gone, then came back.is it possible you left old seal on when changing filters? when testing with tiller do what you can to make sure pto shaft is straight...
-
Dmacleo replied to the thread GC2600 whining gone, then came back.I was just gonna ask if there was a rear pto implement (snowblower, tiller,etc) that could be hooked up to isolate if only front 2k rpm...
-
Dmacleo reacted to Harry in Ky's post in the thread GC2600 whining gone, then came back with
Good Post.
Possible? I guess most anything is possible, but that wouldn't explain why operating a mid PTO would make a difference. What happens if... -
Dmacleo replied to the thread GC2600 whining gone, then came back.yes to both, top off then test with deck on. fwiw I use little red dye to easily see in glass and trace leaks...
-
You are right about the chasing noises. Would be glad for just the whine and no foam at this point.
-
Dmacleo replied to the thread GC2600 whining gone, then came back.foaming could be from deck vibration I suppose. I have a whine with deck engaged, I have cap on tractor and it amplifies the noise...