DMW's latest activity

If this was the pump assembly, it may have been from the factory that way.

I can replicate everything in your video with my GC2300 with underinflated rear tires. Your backhoe is about 200 pounds more than my...

GC's are very heat sensitive. Is the hydrostat cooling fan intact? Did you change the hydro oil with a suitable tractor hydraulic fluid...

Ferris IS1500Z, replaced the key switch. Symptoms - Starter would only click when trying to start, after several dozen attempts it would...

Well, I only see two other switches on parts book. One I would assume to be a neutral switch for starting, whether that is the one on...

Tried jumpering the seat safety switch? Depending on the type, seat foam can get too hard to depress, seat and seating position can...

Wiring Diagram: MF 2300 Replaced my key switch a couple years ago. Showing a bit of corrosion and intermittent failure to crank.

You're good to go. It's Diesel rated. Far better quality than when the Iseki 3 cylinder came out 40+ years ago. The GCs have been using...

Mine has ~1850lbs lift at the pins.. With forks, I could *barely* lift ~900lb pallets of shingles off the flatbed delivery truck, about...

Air can only enter the system from suction. The main filter is under constant pressure while operating.

It is very easy to pinch an o-ring on the suction filter. The early ones were made of plastic, very easy to crack if over-torqued. Part...

Seems like your using a decent semi-synthetic. Symptoms sound like overheating of the hydro fluid. Common causes would be damaged...

Sounds more like the tractor hydraulic fluid you are using. Do you know the Viscosity Index of the hydro oil?