Recent content by Docwho

Did not catch that. The only way it won't matter is if the money difference is significant. After working about a1000 hrs OT this year, I am splerging

Sorry, I am well aware they do not affect one another. I am still weighing options. And was simply pointing out some minor differences I had noted.

The only question I have between the 494C and the 454C is the 454C seems to list a higher hydraulic flow. Almost 2 gal a minute. While lift capacity at 24" is only 112 lbs. different. Pump type Dual Gear Pump Dual Gear Pump Dual Gear Pump Implement flow 7.66 gpm 9.5 gpm 9.5 gpm Steering...

That is good to know. Kind of floating between the T474 and T494 they als list a T494C not sure what this is,

Looking into TYM, they offer models with the Yanmar (powers a lot of compact tractors) or Kukje (unfamiliar with this make). Is there a benefit of one or the other?

Hello Need some help with wiring in auxiliary switches on a 2003 New Holland TC40. The switches have 5 blades. Un-shore of where to bring in the power and what all of the blades are for. Please help! need some good advise.

Does anybody have one of these or have any information on them? Can You mow with these in any position?

Hello Can Anybody give me info about a NH 450 sickle bar mower? 1) Is this a balanced head mower? 2) Can it be used to cut on angles? (banks along road) 3) What would be the approx. price of one of these be?

Hello Can anybody give me information about a Ford 515 3 point sickle bar mower. Are these able to mow at angle's or only flat? What would one of these be worth?

Hello I am looking at replacing my 2003 TC40. I have looked at both the Mahindra and Kioti. Still need to go look at the New Holand and Kubota. Mahindra 4035 PST Kioti DK40SE Please give me postive and negative feed back on 40 hp models. Thank You

My 1995 Ford F350 diesel shuts off when cold. It will run for 5 minutes idiling perfectly then shut off. I will restart and go through the whole process again. The truck will shut off several times or kind of stall when running till the temperature gets to operating temp. After reaching...

Hello Has anybody here converted an old belt drive buck saw to 3 point? And how did you go about it?:(

Hello all I have just signed up and am looking forward to learning much info about tractors and implements.:)