drumminj's latest activity

You need a new small tank and a Cycle Stop Valve. Check here: Constant Pressure Pump Control Valves

I wonder if the nice, friendly posters belittling the OP, calling him a deekhead , entitled, whiny, baby, etc, .. have never returned a...

We have a red fox that frequents our property. He usually goes to check out the chicken coop/run but so far hasn't been able to get in...

In my experience it's the sewer/wastewater fee that's the killer, not the water. Luckily I'm on a well/septic now so don't have to deal...

I didn't expect getting into bees to make me pay closer attention to what's growing and blooming, but alas here we are :). At the end...

Nice! Any photos of your cross cut sled? Crosscutting sheets exactly always seems to be a challenge for me. All the best, Peter

I ran into the same issue when looking for a replacement shaft for my woodland mills grinder. Ended up biting the bullet and buying...

Do you sell off produce, or can? We're drowning in beans with just 16 or so plants, and just planted some more where we pulled up the...

Interesting. Thanks for the suggestion - we did just buy a pressure canner!

Harvested potatoes today. This was from 2/3 of a 3x8 bed. If only we had a root cellar...

We have bats around here, I assume living in some of our dead trees that I need to take down soon. Been meaning to build bat boxes and...

Did my annual/50 HR oil/filter change and air filter service last week. I was going to remove the drain hose and the adapter fitting so...

I still feel like I get more clumping with the gator blades, but haven't sharpened the stock blades and put them back on to verify...

And they take forever to heal! Seems like they take a month or so for me here.

This is also why I haven't sought a mentor. I suspect I would be 'fired' as a mentee pretty quickly as I'm not very good at being dogmatic.