Recent content by dtj1

It is a Massey Ferguson screen and the fluid is compatible with Permatran and Permatran III.

I just put a brand new screen on it and also put new fluid. It's only got maybe 1 hour run time, on it while I was testing it.

Update: After more testing I have now tracked it down to the lift pump. Now I m focused on the lift pump trying to figure it out, what could be wrong with it, while the tractor was running, I started turning the PTO on and off, while watching it. I now see what is happening. When I turn the PTO...

No. 39 in the attachment, I called it a filter. It is supposed to be reusable but I just replace it with a new one.

Yes, No. 10 on the schematic is the one that is for the 3 point lift in this picture, the one with the stand pipe attached on the right of the case, P1 is for my PTO, it is the smaller goldish color steel line on the left side with the banjo fitting on the pump to the priority valve, the block...

I am not sure of the options Massey offered on this model, maybe that is why the diagram is not complete, because of other options for it. I bought the tractor used in 2013 with 800 hours on it. I now have 1254 hours on it and have not had any problems with it until now. It is a factory stock...

This one does not have a screen, it has a filter and it is a new filter.

Yes it was working and then the next time I went to use it, the problem started and it is a stock system. I do have a shop manual from a Massey Dealer that went out of business, it's not very good on the PTO diagram and trouble shooting, but I drew in the missing parts (See Attachment). The...

It had been working but I haven't used bush hog for about a month and when I went to use the bushhog this time that is when I had the problem. I do have a very small amount of oil come out of the hole from the priority valve when the PTO is engaged.

Thanks

Hi. I am new to this forum and I need help. I have a 2008 Massey Ferguson 2625 four wheel drive tractor with independent PTO. When I turn the PTO on, the 3-point lift arms stops working. It has a new Hydraulic filter, and new oil. I am getting 2350 lbs. of pressure at 3-point lift arms test...