Recent content by Dutch445

seems many of our leaders in the know are going to benefit from this, sell high, buy low... sad

that is available thru JD standalone, $18, but the switch is not,,,

trying to find the supplier for this switch with fuse assembly for a light, attempting to install rear work light and use oem switch in the roof of the mauser cab on a JD 1025R, price from supplier is not even comprehensible, possible language barrier! here is the holder, and a pic of a switch...

Had a tempur batter fried appetizer earlier this year at a local restaurant, tasty...

Driver ticketed for strapping ATV to car’s roof | WSYR

finally got the boat in monday, and the corner wedge and stairs, coming nice, wife is happy with the larger swimming area by the stairs for the smaller grandkids. can't say that the rock and jog in the dock is an issue at all.

we did offset the 2nd section of dock to go around the big rock, it's going to be fine. still have to finish with the steps and corner dock piece, but with this 2nd piece of dock we gained a much wider swim area, and will have easier access onto the front of the boat from the dock.

you can see how much you have moved the structure, as others mentioned, 100+ years is a long time. the structure has conformed to it's foundation over the years. i think you will be fine getting the walls as plumb to the overhead structure as you can for now and trying pressure over time to...

we have peroxide injection for our home water system, i dilute the 7% with water, so it's really only 3.5%. today we had a leak at a copper fitting for the injection system where it meets the 3/4 in copper main water pipe. i removed the T for fear it may be bad, and was surprised to see the...

might be easier to just jog the deck out for that 2nd section, offset it, would only need to be offset about 1 foot.. and wouldn't be horrible as the lateral run for the boat could could be right where the offset is

I have a rock in the way of some dock we want to put along shore, it's showing about 24" wide and maybe 28-30" tall, but no idea of how big it really is, can't see it all yet. i tried chipping with a pick axe, it seems pretty hard, has some color to it, we're located in upstate NY, any...

the check came, i called the contractor, they were there monday and had the tree off the roof in about 3 hrs, no further damage, everything good to go, time to start finishing up the deck railings and get the docks in!

i went over again last night and did some rough measuring the tree is 13-14 inches at the base, most of it is around 12, i believe white pine, so around 2000 lbs total give or take.. the top is hanging free with only a few scrub trees below it, and no good trees near it to hang from or tie...

had a bit of a wind blow thru this afternoon, and a smaller pine tree fell on our little camp building. looking at the roof i think we lucked out, i didn't notice any major damage yet. but i need to get this removed before more wind takes it down further. thoughts on safe procedure to remove...

I recently acquired a 16' section of aluminum dock that had a little wind damage. i was able to bend back the area that was damaged, but notice there are 4 support rods that the weld has broken. i'd like to reweld these before we put the dock in for summer. is it worth trying to use the...