Recent content by dzmac

Wondering if anyone has advice on initial hydro filter change. Difficult, concerns, dangers etc. At 50 hours and dealer not close. Am rather handy but dont have significant hydro system experience. Any help or suggestions appreciated. Thanks:)

Anyone have any bright ideas about where to mount a tool box on one of these? It seems as if every good space is taken. I have the backhoe so can't go behind seat.

After reading other forums and duplicating some of the other bx dollies, I ended up making the following for my backhoe. The bx designs were only 48" long and after my initial attempt, I realized that I needed approx 12" more in of length. Keeping in mind that I'm not that experienced, it was...

Just got my Max 28 with fel, mmm, and backhoe. My question is, do i need to remove the backhoe to unhook the mmm? Or in other words, do the hydraulics to the backhoe override the power to mid mount lift capacity as i can't seem to lower the deck to disconnect. Any help appreciated, as i would...

I was reading the manual and it states that all tractors have amid pto cover. Mine arrived with a MMM and no cover. I asked the dealer and they indicated that there is no such thing? It would seem it should be covered based on its location. Does anyone have one? Did it come with the tractor?

Is it normal for the engine to be killed by leaving the seat if in neutral, e brake on, all pto levers off? Also seems a bit sticky trying to find neutral with the hst fwd/rev making starting a bit tricky at times. Figuring the latter is due to being new/spring tension or might need adjustment...