Recent content by Ed Wells

I am in the process of overhauling a kubota D722-E diesel motor which came out of a zero turn mower. The pistons have the number 3 stamped on top. Is this an oversized piston and if so, what is the oversize amount? Thanks for any information you can share with me.

Does anyone know if you should put transmission/hydraulic fluid or 80/90 wt gear oil in the transmission reservoir for this tractor?

Earlier this year I wrote in for advice about low compression on my Yanmar 240D after overhauling the engine. After much trial and error, I discovered there was a small crack in the head and I am happy to report that problem has been solved. It seems the previous owner was using ether to start...

Does anyone know where I can order an exhaust manifold for a YM240D? Hoye Tractor does not have it.

I just purchased a 240D that has been broke down for 4 years with a blown head gasket. I replaced the head gasket following the instructions in a repair manual which suggested I coat the gasket. I used copper coat. While in the motor, I replaced the rings, rod bearings, and valve seals. I...