Recent content by EdK

Reading right out of my Dodge Ram Cummins owners manual it is stated my vehicle has a GCWR figure of 16,000#. Now just one page earlier it specs out a Gross Trailer Weight (GTW) of 13,600# provided the appropriate Class IV hitch is installed. I may be a towing and trailering newbie but something...

I'd like to come up with a hydraulic pump configuration that would allow me (1) two-stage log-splitter type operation as well as the ability to (2) run a 8-10 gpm 2000psi accessory motor (not all at the same time - through valving). Of course, one could just keep it simple and run the splitter...

What can anyone tell me about a Fermec TLK760 TLB - good, bad or ugly? It is vintage '96-97, just before bought out by Terex from what I understand. Clearly it is not mainstream Case/Cat/JD so long term support might be an issue I suppose although there is a Terex dealer not too far away (which...

I bought a Case 580E about 1 year ago. After living with it I am pleased with the engine, trans and loader. My only gripe is the main bushing for the boom in the swing tower - it does have some slop. The swing cylinder bushings themselves are a just a little bit sloppy but might as well redo...

Does anyone own or have built an electric wood splitter? I see the little electric ones but I'm talking more along the lines of a full-size unit (e.g. 5hp motor, 16GPM 2-stage pump, 4-1/2"x30" ram, etc.) Right now I have access to a gas powered unit that my brother and another guy co-own...

I am looking to buy a generator and have followed the story line on how an engine-driven welder makes a lot of sense - particularly from the perspective of being a fellow TBNer who'd like to learn welding to support my habit. However the timing is such that I'm presented with the opportunity to...