Not the quick disconnect . I have that for the short shaft. If you look you will see the spline shaft coupling for this. On the long shaft the PTO engages differently. Also doesn't connect direct. Tried that today. Pull PTO engagement lever but gear doesn't go out far enough to engage...
Had a 30" Mower deck given to me that is made for the walk behind with the long shaft. I also currently have the short shaft new style deck with the grease fitting on top and hooks up to the quick disconnect coupler with a splined tube that goes between the tractor quick disconnect coupling and...
Well I finished up my 5200 this past week. I decided to repower it after not being able to get the old 8HP engine to crank up after sitting for over a year. Thanks to Bruce and others for their info. Started off kind of rough. This is during the tear down phase.
Here i started to repaint...
Ok I got my 5200 up and running with the new Honda Clone engine. Runs great. Only thing is I have adjusted my forward and reverse rods and they work fine. Hig and Low rods are also adjust but here in lies the problem or so I think. I move the high low lever to a neutral position and when I...
Looking to find a engine to transmission plate for a 10 to 12 hp Kohler. I am in the process of a re-power on my 5200 and my 8 hp plate uses the 4 symetrical holes that are towards the middle. The 10 to 12 hp plate uses the 4 outside holes like you see in the pictures from Bruce on his...
I got a 5200 given to me and I am going to take this on as a restore project. I've steam cleaned the housing to do a repaint. As I start to disassemble I am taking note of the parts that will need to be replaced. I see that the Control Level Threaded rods that are used to adjust the forward/...