Recent content by Farmer Scott

  1. F

    Engine serial number for my MF 35X

    Anyone have any information as to the letter A in my engine serial number of my MF 35X perkins 3 cylinder diesel built in the UK. When I go on AGCO parts manual online I don't see a range of numbers for various parts for the engine serial number with the letter A. Most times the parts...
  2. F

    Body Panels for MF 35 - need input

    Can anyone recommend good replacement body panels for my 1964 MF 35 deluxe 3 cyl Perkins? What brand names are the best? Sparex? Vapormatic? QTP (quality tractor parts)? What is a good online store to buy from. Any information about your experience good or bad is very much appreciated...
  3. F

    MF 35 or 35X what do I have

    I bought a second MF 35 tractor last summer and I am trying to figure out what I actually have. 35 or 35X. It's a 1964 MF 35 3 cylinder Perkins. serial number SNMY 353514. Number stamped on the block in front of the exhaust manifold near the water pump elbow on the left side of the...
  4. F

    MF 35 Instrument Panel - anyone interested in it?

    Anyone interested in this new instrument panel for a MF 35. This was bought new last fall. I thought I was getting a new painted red one as per the Sparex part listed on a particular online parts store with online photo and would just be able to install my gauges and done with. I even...
  5. F

    MF 35 lift arms won't lower

    1959 MF 35 with 2 spool valve with levers in front of the seat. As soon as I start the tractor the lift arms go all the way up and the pump continues to try and lift further. I bought this tractor a month ago and the previous owner used the left lever on the 2 spool control valve in front...
  6. F

    MF 35 loaded rear tire capacity

    Anybody know the volume in gallons required for loading a rear tire on a 1964. Thanks Scott
  7. F

    boot for hydraylic lift MF 35

    What is involved in replacing the boot for the hydraulic lift top link as shown in the photo below as part #7 Is there a simple way to do it or do I have to remove the lift cover? Any input is greatly appreciated Thanks Scott
Top