Recent content by fma1015

Any more ideas for switching these out? I am not very good with a wrench and have been dreading this, but I missed my May mow and need to make it happen. I just don't want to raise the tractor and do anything stupid that will leave me worse off. Thank you!

It looks like just two bolts each and my question about how to get the wheels the two inches or so off the ground without crushing myself. Can I do the job with all the weight on the bucket with some wood blocks under the axle? Any reason I can't take the bent ones off before lifting the wheels...

Lost all fluid. I had a few gallons and partially refilled it. When I put the metal line into the rubber hose, there was hardly any slack in the rubber hose and it just barely covered the metal line when I put the hose clamp on. I would think one would want it on better, but there was no slack...

Rookie move back up with brush hog down. Can I still use a 5' rotary cutter with no wheel on the back without harm to the tractor L3400? Thank you.

I did not know the clutch of the mower was bolted on so the drive shaft separated for the mower. I found the bolt, but the clutch end of the drive shaft did not want to slide back on the mower end. Do I? Detach the clutch from drive shaft and bang it on and hope I can line up the holes that...

I have 336 hours on a ten year old Kubota L3400. For the third time in the last two years I ran a front tire off the rim. The first time, easy remount. Next time, other tire easy remount with new valve stem. Today, first tire goes off over a little stump strong turn and a wire is sticking out of...

When engaging the PTO on my Kubota L3400, I get a grinding sound. It does not matter if the attachment (mower) is attached or not, it still grinds. Can you help me figure out what to do? After doing a little research, I did this and: I adjusted the freeplay of the clutch pedal. I can get the...

When engaging the PTO on my Kubota L3400, I get a grinding sound. It does not matter if the attachment (mower) is attached or not, it still grinds. Can you help me figure out what to do? After doing a little research, I did this and: I adjusted the freeplay of the clutch pedal. I can get the...