Recent content by gasman1075

If it is an option for your tractor I have been very happy with my front mounted snowblower I do 4 driveways ( my neighbors ) in 1.5 hours and very little damage and a 32HP tractor.

a 100 gallon tank at 20' F and at 40% capacity will vaporize up to 235,000 btu/hour. A 100 lb tank has about 22 gallons in it and will vaporize about 79,000 btu when full but much less as the liquid level decreases. Owning your own tank means you can shop it when you need it. You can manifold...

When I used to teach for Vermont Castings I used that trick but always with someone else's dollar bill !

The dealer said fuel gelling can also be a culprit. Its plugged in and warm now so no code. Thanks

well I plugged it in and warmed it up and no more error code but thanks !

Thanks

I have a 2303R and am getting the ECU 1209.3 error code on the display It started right up I let in run for 20 minutes ( it was 12' F here this am ) it moved fine so I just parked it and plugged it in. I have a call into the dealer any thoughts ? Thanks in advance

horizontals are ASME tanks. Verticals can be ASME tanks or DOT cylinders.

low sulfur fuel oil varies between 118,200 btu / gallon to 128,000 btu / gallon. At 92% efficiency it makes LP more competitive. Especially since it is domestically produced and readily available. And much cheaper than #2 if you own your own LP tank.

We have been burying propane tanks where possible for decades. And they are safer under ground then above as long as they are marked so idiots don't drive skid steers or tractors or mowers or ATV over them and shear off the fill valves. ( ask me how I know ). Also the temperature underground...

different manufacturers offer zero clearance wood burning manufactured fireplaces and some are better than others as you know. a decent hearth shop should be able to help you. no footings required but as with any natural vent appliances a good draft is required.

Well we had the last court date last week and he pled to a lesser charge ( somebody called it ) had to pay restitution to us and also a 125 charge to NYS and we got a 2 year order of protection. So hopefully this chapter is over. ( I am leaving the cameras up however )

It should be a pretty easy install for the LP company. Install a tee with a shut off pointing towards the regulator and install a quick dis-connect after the second stage regulator before it goes into the house. You have CSST going into your house so there is flexibility Make sure the quick...

too heavy too far. if I can find pictures I will post them

I did the same thing on my JD790 and just put in a power beyond kit in the back and plumbed if off that. I think I may still have the valves and hoses if you are anywhere near upstate ny