gengine's latest activity

DarkBlack; I checked the radiator like you suggested, coolant is bright and green, although I didn't start it, I don't want to until I...

If this is accurate, I wouldn’t suspect valve stem seals. They harden and wear over time, and slowly start letting more oil by. When...

In a regular vehicle with good roads, Laramie the Guernsey was and hour and a half. In Humvees only the trip was closer to two hours. In...

I do not miss the SEE trucks. Miserable to convoy down the road in, the seat had a foreword tilt so you have to use your legs the entire...

I just saw the second page, oops. I had a Kubota engine in a generator where the crankcase vent was plugged with ice. A rubber plug blew...

It's been a little while fallas, I apologize. A bigger project came up and it'll take some time before I can really get this into the...

Thanks for the reply Boomer, I will try that this week.

I don't know your area, but if you have a beet or a potato farmaround you, ask for a scrap of their conveyor belt. 1/4" thick and very...

Complete oring kit: Ford 4000 Hydraulic Valve O-Ring Kit - DHPN485A

Set everything out, look at it, think logically, then just kinda wing it. Who's to tell ya it's wrong? If it don't work, modify and...

Broken rings? Valve stem problem? Firing on all cylinders?

might do a compression check to start if you can get the right gauges, procedures best of luck

Clogged crankcase vent?

The 3020 Deere is a heck of a lot bigger than a single cyl Honda, but engines are engines. Valve seals are very likely in both cases. I...

Welcome to TBN! Since your description is vague and we have no pictures, one can only assume you mean one like #13 in picture. There...