Recent content by goneblue

this works for me

primed and ready to put the blades on then paint.

still have some bracing to do and runners on the bottom and blades.

I am building a land plane and can't decide which way the blades should be, straight or angled. The more expensive ones have an adjustment for both ways. Since the land plane sits flat, it would seem the only difference would be having the material roll over or travel in the direction of the...

Just finished loading a 30 yd dumpster . I ordered a 20 but they brought a 30. It was fine for this job but on level ground the fel just clears by 1" or so. Depending on the situation you could drive on ramps to add height or you could put dirt around the dumpster to add height or some board,s...

it also works good at moving rocks

I am trying new things with it all the time

sorry it is not for sale, best 300 bucks I ever spent! After using it for awhile now I am glad it mounts on the FEL and not the 3 PT. way more versatile. I have a hydraulic top link and still it would not even compare to using it on the front. great for hooking on to things and moving them, i...

Got a golf cart top and some steel tubing for less than $100 and welded up a top for my G3038H and it fits in a regular single car garage. The way I welded the frame makes the top come on and off and the rops pulls back and have about 1 inch clearance to get in my garage. added a hyd. top link...

I was going to build one of these but had plans to make a 3 pt hitch type, similar to a sub soiler only with a longer reach. I found this for sale by a tree service company that used it on a skid steer. They built it and said they spent $850 on the metal. Heavy 3/4 " and 2" x 4" supports. I...

Saw a tan , light brownish stain around my fel valve, plus it was feeling just a bit sticky. 16 hours on my G3038H. Cut the plastic tie holding the bottom of the shift boot. Boot was fine, no cuts and was sealing fine. Looks like someone left about 38 yards of Mississippi river bottom in there...

Got a can of LS blue from my dealer and took it to sherwin williams and they made me a gallon of industrial enamel. Very good match on tractor , after it dried I could not tell where I touched up. Very tough paint, almost as good as 2 part epoxy. Can be sprayed, rolled or brushed. The gallon is...

http://youtu.be/Ook80XpSBzQ